Cobra C2204/58 Motor Propeller Data
	Motor Wind		Motor Kv		No-Load Current		Motor Resistance		I Max	P Max (3S)
	58-Turn Delta		1080 RPM/Volt		Io = 0.20 Amps @ 8v		Rm = 0.318 Ohms		7 Amps	75 W
	Outside Diameter		Body Length		Total Shaft Length		Shaft Diameter		Motor Weight
	27.0 mm, 1.06 in.		14.2mm, 0.56 in.		21.8 mm, 0.86 in.		3.0 mm, 0.118 in.		22.5 gm, 0.79 oz
	Prop	Prop	Input	Motor	Watts	Prop	Pitch	Thrust	Thrust	Thrust Eff.
	Manf.	Size	Voltage	Amps	Input	RPM	Speed	Grams	Ounces	Grams/W
	APC	8x3.8-SF	7.4	3.38	25.0	5,924	21.3	233	8.22	9.33
	APC	8x6-SF	7.4	4.88	36.1	5,097	29.0	250	8.82	6.92
	APC	9x3.8-SF	7.4	4.29	31.7	5,412	19.5	281	9.91	8.86
	APC	9x4.7-SF	7.4	4.71	34.8	5,194	23.1	294	10.37	8.44
	APC	9x6-SF	7.4	6.02	44.6	4,421	25.1	295	10.41	6.62
	APC	9x7.5-SF	7.4	6.62	49.0	4,010	28.5	260	9.17	5.31
	APC	10x3.8-SF	7.4	5.64	41.8	4,566	16.4	325	11.46	7.78
	APC	10x4.7-SF	7.4	6.02	44.6	4,356	19.4	333	11.75	7.47
	GWS	8x4-DD	7.4	2.65	19.6	6,314	23.9	202	7.13	10.31
	GWS	8x4x3-DD	7.4	3.15	23.3	6,036	22.9	220	7.76	9.44
	GWS	8x4.3-SF	7.4	3.56	26.3	5,812	23.7	228	8.04	8.66
	GWS	9x4.7-SF	7.4	4.94	36.5	5,015	22.3	298	10.51	8.15
	GWS	9x5-DD	7.4	4.20	31.0	5,463	25.9	280	9.88	9.02
	GWS	9x5x3-DD	7.4	4.90	36.3	5,033	23.8	292	10.30	8.05
	GWS	10x4.7-SF	7.4	6.30	46.6	4,229	18.8	340	11.99	7.30
	GWS	10x6-DD	7.4	5.25	38.8	4,871	27.7	323	11.39	8.32
	GWS	10x6x3-DD	7.4	6.14	45.4	4,292	24.4	330	11.64	7.27
	Prop	Prop	Input	Motor	Watts	Prop	Pitch	Thrust	Thrust	Thrust Eff.
	Manf.	Size	Voltage	Amps	Input	RPM	Speed	Grams	Ounces	Grams/W
	APC	7x4-SF	11.1	4.23	47.0	8,929	33.8	324	11.43	6.90
	APC	7x5-SF	11.1	4.85	53.8	8,531	40.4	326	11.50	6.06
	APC	7x6-SF	11.1	5.75	63.9	7,951	45.2	315	11.11	4.93
	APC	8x3.8-SF	11.1	6.08	67.4	7,735	27.8	427	15.06	6.33
	GWS	7x3.5x3-DD	11.1	3.33	36.9	9,528	31.6	269	9.49	7.28
	GWS	8x4-DD	11.1	4.71	52.3	8,638	32.7	383	13.51	7.32
	GWS	8x4x3-DD	11.1	5.49	60.9	8,138	30.8	404	14.25	6.63
	GWS	8x4.3-SF	11.1	6.01	66.7	7,804	31.8	416	14.67	6.24
	GWS	9x5-DD	11.1	6.97	77.3	7,141	33.8	493	17.39	6.38
	Propeller Chart Color Code Explanation
		The prop is to small to get good performance from the motor. (Less than 50% power)
		The prop is sized right to get good power from the motor. (50 to 80% power)
		The prop can be used, but full throttle should be kept to short bursts. (80 to 100% power)
		The prop is too big for the motor and should not be used. (Over 100% power)
	PLEASE NOTE:
	The data contained in this prop chart is based on actual measurements taken in a controlled test
	environment. The test voltages used are based on a properly sized Li-Po battery for the current
	draw of the motor being tested. If you are using a larger than normal capacity battery, or a very high
	C-Rated battery, your actual voltages will be higher than those shown in this chart, and this will
	result in higer current draw for each prop used. You should always test your power system with a
	watt meter whenever a prop is used to ensure that you are not exceeding the recommended rating
	of the motor being used. The prop recommendations in this chart are based on the motor receiving
	adequate cooling throughout its operation. If your motor is being used inside a cowl, you must
	provide adequate cooling to the motor and make sure that the motor is not getting too hot during
	operation.